Installing The Hob - Neff M R40 Serie Gebrauchs- Und Montageanleitung

9.3 Inserting the hob into the wider cut-out
Create the wooden battens in accordance with the
1.
drawing.
Check and adjust the cut-out dimensions.
2.
9.4 Installing fixing rails
For stone work surfaces, bond the fixing rails in place.
¡ The hob can also be installed in an existing cut-out
that has a depth of 500 mm.
9.5 Connecting the hob
Requirement: The cooker must be connected to the
mains, but switched off.
Screw the PE conductor (green/yellow) for the hob
1.
to the cooker's earthing point ⁠ .
Plug the hotplate plug into the cooker.
2.
The colour of the cable should match the colour
shown on the label.
Screw the wooden battens in place so that they are
3.
flush with the upper edge of the worktop. For stone
work surfaces, bond the wooden battens in place.
9.6 Installing the hob
Ensure that the cables are not trapped or pinched, and
do not route them over sharp edges.
¡ Push the hob in until it locks into place.
Installation instructions en
17