Herunterladen Diese Seite drucken

Grundig WKC 2804 VD Service Seite 2

Werbung

Mechanischer Teil
Bei
Eingriffen SchutzmaBnahmen fiir MOS-Bausteine beachten!
Allgemeines
Zahlen im Text und bei den Abbildungen sind mit den Positionsnum-
mern in der Ersatzteilliste identisch. Teile, die in der Ersatzteilliste
nicht vorkommen, sind mit Buchstaben gekennzeichnet. Naher be-
zeichnete Hilfsmittel, z.B. Testbandcassetten, kénnen von den
Service - Stellen bezogen werden.
Flexprinthalter éffnen
Ausbauhinweise
Gert Sffnen und schlieBen
Die beiden Deckel kénnen mit einem Schraubendreher angehebelt
und dann abgenommen werden.
Beim SchlieBen des Gerates die Vorderseite des Deckes in die 3 Rast-
nasen d_ einhangen und dann den Deckel auf den Rahmen driicken.
Blende abnehmen
~ Die beiden Deckel abnehmen.
- 2Schrauben a herausschrauben.
- 2 Abstandsrollen b herausnehmen.
- Bagel abnehmen.
- Drehknopf 9 abziehen.
- 2Schrauben e herausschrauben und 2 Einbaufedern f
abnehmen.
- Flexprinthalter 6ffnen und Flexprint herausziehen (STV2).
- 2Rastnasen ¢ ausrasten und Blende nach vorne abnehmen.
~ Steckverbindung STV 1 abziehen.
Mechanical Section
NB. When carrying out repairs, observe MOS precautions!
Introduction
The figures in the text and in the diagrams are the corresponding
position numbers in the spares list. Parts not included in the spares list
are denoted by letters of the alphabet. Servicing aids such as test tape
cassettes which have been given detailed descriptions can be obtai-
ned from sales and service centres.
Open the flexprint holder
Disassembly Instructions
Opening and closing the Unit
The top and bottom covers are lifted off with a screwdriver and can then
be removed.
For closing the car radio fit the front side of the cover to the 3 catches
d and press the cover on to the frame.
Opening of Control Unit
= Remove 2 covers.
- Remove'2 screws a .
- Remove 2 disdance pieces b.
- Remove.the handle.
- Remove the rotary knob 9.
- Remove 2 screws e and 2 mounting springs f .
Open the flexprint holder and remove the flexprint (STV 2).
Disengage 2 notches ¢ and take away the mask.
Pull off the connections STV 1.

Werbung

loading

Diese Anleitung auch für:

Wkc 2803 vd