Streetz S250 Bedienungsanleitung Seite 6

ENG
1. USB-C female (charge port, and LED indicator)
2. MicroSD slot
3. USB-A female for USB flash drive
4. 3.5 mm audio female ("AUX")
5. Decrease volume/previous song
6. Increase volume/next song
7. Mode button
8. Power button on/off/play/pause/answer/hang up
Charging
1. Use the USB-C cable to connect to the speaker and to a USB
adapter 5V, 1A (not included).
2. The LED will change to red light, confirming it is charging. When it is
fully charged the LED will turn off.
Use
Press and hold the power button to turn the speaker on or off.
Short press on the power button to play or pause.
Increase volume: Short press on the "+" button.
Decrease volume: Short press on the "- " button.
Previous song: Long press on the "-" button.
Next song: Long press on the "+" button.
Press the mode button to switch between Bluetooth, MicroSD
and USB.
If a USB flash drive or a MicroSD card is already inserted or just
inserted, then music will play automatically.
To use a MicroSD card or USB flash drive USB insert them into the
corresponding slot.
To use 3.5 mm audio connection. Connect a 3.5 mm cable to the
speaker and to another device. Use the other device to control and
play music.
File type supported for music: MP3.
Bluetooth
1. Turn on the speaker. Bluetooth range is up to 10 meters.
2. Press the mode button to change to Bluetooth.
3. Use your phone or device to connect to the speaker. If needed see
the manual of your device on how to use Bluetooth. If a pin code is
requested, enter "0000".
4. Use your phone or device to play and control the music.
While using Bluetooth the following buttons works from the speaker.
Previous song: Long press on the "-" button.
Next song: Long press on the "+" button.
Short press on the power button to play, pause, answer a call or
to hang up.
Troubleshooting Bluetooth
Only one Bluetooth connection can be used at the same time.
If the connection fails, try forgetting the speaker from your device and
try to connect again. It might help to forget or remove other Bluetooth
devices as well.
TWS
2 speakers with the same article number are required for "TWS".
"TWS" is short for "True wireless stereo", it means that you can
connect 2 identical speakers wirelessly and play music from both in
stereo, for a better music experience.
1. If either or both speakers are connected to your phone or other
device, then first turn off the Bluetooth on your phone or device.
2. Turn on 2 speakers. Change them both to Bluetooth. A LED flashes,
to confirm that the speaker is ready to pair.
3. On one of the speakers, press and hold the mode button until a
sound confirms. Wait a few seconds, now another sound should play
and one of the speakers should have a flashing LED and the other
should have a not flashing LED to confirm successful pairing.
4. Use your phone or device to connect to the speaker. If needed see
the manual of your device on how to use Bluetooth. If a pin code is
requested, enter "0000". A sound confirms successful connection.
5. The speakers are now paired together and connected to your
device. Try playing some music, you should hear music from both
speakers now.
Disconnecting "TWS"
To disconnect, press and hold the mode button. They will disconnect
from each other.
Voice assistant
Press the mode button 2 times to activate the voice assistant function
on your phone or device.