The Administration Tab - Factory Defaults; The Administration Tab - Firmware Upgrade; The Administration Tab - Config Management; Chapter 6: Configuring The Wireless-G Broadband Router The Administration Tab - Factory Defaults - Cisco Systems Linksys WRT54G Bedienungsanleitung

All manuals and user guides at all-guides.com
Wireless-G Broadband Router

The Administration Tab - Factory Defaults

Click the Yes button to reset all configuration settings to their default values, and then click the Save Settings
button. Any settings you have saved will be lost when the default settings are restored. This feature is disabled by
default.

Figure 6-42: Administration Tab - Factory Defaults

The Administration Tab - Firmware Upgrade

Firmware can be upgraded by clicking the Upgrade button after browsing for the firmware, which you can
download from the Linksys website. Do not upgrade your firmware unless you are experiencing problems with
the Router. For more information about upgrading firmware, refer to "Appendix C: Upgrading Firmware".

Figure 6-43: Administration Tab - Firmware Upgrade

The Administration Tab - Config Management

This screen is used to back up or restore the Router's configuration file.
To back up the Router's configuration file, click the Backup button. Then follow the on-screen instructions.
To restore the Router's configuration file, click the Browse button to locate the file, and follow the on-screen
instructions. After you have selected the file, click the Restore button.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel
Changes to cancel your changes

Figure 6-44: Administration Tab - Config Management

Chapter 6: Configuring the Wireless-G Broadband Router 56
The Administration Tab - Factory Defaults