Werbung
Verfügbare Sprachen
Verfügbare Sprachen
head while the chinstrap is undone. The helmet should not move
about. An optimal fit is necessary for the helmet to fully achieve its
safety function.
6. Adjusting the chinstrap
a)
Close the snap-in clip (see illustration 3). Slide the strap tensioner (see
illustration 4) so that the front and rear strap come together below the
ear, and centre the snap lock below the chin. If the straps are not tight
and closely fitted, you will need to re-tighten the excess length of the
strap using the snap lock. To do so, open the locking plate on the male
part and adjust the strap length (see illustration 6). Repeat this process
until the strap system is tight and closely fitted. Firmly lock the locking
plate again at the snap lock. The snap lock must not lie directly on the
chin.
b)
The chinstrap should fit tightly but not impair your ability to breathe
or swallow.
7. Extras
7.1 Light
The K-FIT adjustment system is equipped with a flashing light. You
can turn the flashing light on and off by pressing it in the middle. The
following functions are available:
Press once for a continuous light,
press twice for a flashing light,
press three times to turn off the light.
Changing the battery: use a slender Philips screwdriver to open the
compartment (see illustration 7), remove the circuit board and replace
the battery)
8. Care, cleaning and storage
The comfort padding can be cleaned using a damp cloth. Use a mild
soap solution or heavily diluted delicate detergent as the cleaning
agent. The comfort padding and straps should be dried at room
temperature.
The helmet shell should be cleaned using lukewarm water and a mild
soap solution. Do not use any solvents, e.g. thinner or similar.
Excessive temperatures or strong UV radiation can damage your
helmet. You should therefore not store your helmet above 60°C; a tem-
perature which can be reached on the rear shelf of a car for example.
Do not place it directly onto or near a heat source such as an oven. The
13
Werbung
