Herunterladen Diese Seite drucken

Makita CW002GZ Gebrauchsanleitung Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
4. Selecting the control temperature
Press the temperature setting button to select
the control temperature. Refer the chapter
"SPECIFICATIONS" for the selectable control
temperature.
The appliance starts cooling / heating 5 seconds after
without any operation, then the control temperature stop
temperature.
The appliance stops cooling / heating when the current
temperature reaches the control temperature.
Opening the upper cover for long periods can
temperature in the chamber.
Regularly clean surfaces that can come in contact
with food and accessible drainage systems.
the chamber, so that it is not in contact with or drip
onto other food.
If the chamber is left empty for long periods:
- Defrost the chamber.
- Clean and dry the chamber.
- Leave the upper cover open to prevent mould
developing within the chamber.
FUNCTION
Indicating the remaining battery
capacity
The battery indicator shows the remaining battery
capacity. The remaining battery capacity is shown as
the following table.
Battery indicator status
Lighted
(Blinking)
(Only for battery cartridges with the
indicator)
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for a few seconds.
Fig.3 1. Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
from the actual capacity.
NOTE:
the battery protection system works.
system
The appliance is equipped with the protection
extend appliance and battery life. The appliance will
Remaining
automatically stop during operation if the appliance or
capacity
battery is placed under one of the following conditions.
50 % to 100 %
20 % to 50 %
0 % to 20 %
Charge the
battery.
10
ENGLISH
Indicator lamps
Battery overdischarge protection
When the battery capacity becomes low, the
appliance stops automatically. The battery
indicator prompts that the battery should be
charged. Remove the batteries from the appliance
and charge the batteries.
Overcurrent protection
When the appliance / battery is operated in a
manner that causes it to draw an abnormally high
current, the appliance automatically stops. In this
situation, stop the application that caused the
appliance to become overloaded. Then turn the
appliance on to restart.
Low-voltage protection
When the car input voltage is lower than the
appliance and the temperature display shows "F3"
with beep sound.
2. Check button
Remaining
capacity
Blinking
75 % to 100 %
50 % to 75 %
25 % to 50 %
0 % to 25 %
Charge the
battery.
The battery
may have
malfunctioned.

Werbung

loading

Diese Anleitung auch für:

Cw002g