Installation - Sony CDX-G1102U Bedienungsanleitung

After matching the connections and switching
power supply leads correctly, connect the unit to
the car's power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.

Installation

Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar  and the bracket  from the unit.
1
Pinch both edges of the protection collar
, then pull it out.

2
Insert both release keys  until they
click, and pull down the bracket , then
pull up the unit to separate.


Face the hook inwards.
Mounting the unit in the dashboard
Before installing, make sure the catches on both
sides of the bracket  are bent inwards 2 mm (
in).
1
Position the bracket  inside the
dashboard, then bend the claws outward
for a tight fit.
2
Mount the unit onto the bracket , then
attach the protection collar .

Notes
 If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
 Make sure the 4 catches on the protection collar 
are properly engaged in the slots of the unit.
Detaching and attaching the front panel
For details, see "Detaching the Front Panel"
(page 5).
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
3 /
32
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
182 mm (7
53 mm (2 1 / in)
8
Catch



1 / in)
4

Fuse (10 A)
17
GB