Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. Removing from service
If you need to disconnect the hose from the waste water pump (e.g. for cleaning, maintenance or winter storage),
proceed as follows:
• Disconnect the waste water pump from the mains voltage by pulling the mains plug out of the mains socket.
• Pull the waste water pump out of the water by the fastening rope or the carrying handle.
The waste water pump must never be pulled out by the power cord, float switch or hose! Otherwise the
power cord may get damaged, risk of an electric shock!
• Disconnect the hose from the waste water pump.
• Allow residual water to run out of the waste water pump by holding it tilted.
• Allow the waste water pump and power cord to dry completely. Then wind up the power cord.
• The waste water pump must be stored in a frost-proof and dry room during winter.
Also do not forget to empty the hoses laid outdoor to avoid frost damages; open water taps if available.
• Only carry or transport the waste water pump by the carrying handle. Never carry it using the hose or the power
cord.
• A small amount of water may still remain in the waste water pump after operation or emptying. Therefore, when
storing or transporting the pump in a vehicle, use an appropriate mat.
10. Cleaning and maintenance
The waste water pump has no user serviceable parts, so never open or dismantle it. Maintenance, repair and associ-
ated opening of the waste water pump may only be carried out by a specialist or a specialist workshop.
Before cleaning the waste water pump, disconnect it from the mains voltage by pulling the mains plug out of the
mains socket.
Use a clean, soft cloth to clean the outside of the waste water pump. If necessary, rinse the outer surface with clear
water.
Dirty suction openings can be cleaned with running water (e.g. with a garden hose). The inside of the waste water
pump can also be rinsed out with running water by removing the hose and any connector attached.
Allow the waste water pump and power cord to dry completely before putting them in storage.
Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may damage the
housing or stop the product from functioning properly.
23
Werbung
