Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual IB-2915MSCL-C31
•
As soon as the status LEDs TARGET and SOURCE light up continuously, press
and hold the „clone" button (1) for ca. 5 sec. to activate the clone mode.
•
As soon as all LEDs light up permanently, press the „clone" button (1) again
to start the cloning process.
•
When the 25% LED and the LEDs (2) of the source SSD and target SSD start
flashing, the cloning process has started.
ATTENTION: DO NOT stop or turn off the device until the clone process is
finished completely!
•
If 25%/50% & 75%/100% LEDs (2) light up in pairs and alternately, an
error occurred.
Please Check:
- If the TARGET drive is larger or the same size as the SOURCE drive
- If one of the drives is damaged.
- If the cloning direction has been set correctly.
•
Please turn off the device and change to a suitable or functional drive.
•
When the cloning process is successfully completed, all LEDs (2) light up
continuously.
•
Switch off the clone station with the ON/OFF button (7).
HINT: To uninstall the drives please make sure that the device is turned off.
1x
~5s
Werbung
