OKBABY FLAT Anleitung Seite 6

INSTRUCTIONS FOR THE OKBABY FLAT CHANGING TABLE CODE NO. 839
EN
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
CONFORM TO EN 12221-1:2008+A1:2013
WARNING!!!
NEVER LEAVE THE CHILD UNATTENDED NEVER LEAVE THE CHILD UNATTENDED
TYPE 1
MAXIMUM BABY WEIGHT 11 KG
MAXIMUM BABY AGE 12 MONTH
Flat changing table can be adapted for use in different situations: on a stable table,
on a cot or over a bathtub.
Product dimensions: 66.2 cm x 84.6 cm x 18.3 cm.
USING FLAT ON A STABLE TABLE OR WORK SURFACE
(minimum surface area 67 cm x 85 cm)
1. Fold away Flat supports making sure that they are blocked by the lock on the side
underneath the changing area (fig.1).
2. Place Flat on a flat, stable surface (fig.2).
3. Make sure that all the non-slip feet (fig.3) are touching the table or work surface to ensure
maximum stability.
USING FLAT OVER A BATHTUB
(minimum internal width of bathtub 56 cm, maximum 74 cm)
1. Release the side lock underneath the changing area to free Flat supports (fig.4).
2. Open Flat supports completely, making sure that the red clasps hook completely into place
on the sides of the changing table (fig.5). Make sure to install the cross bar (fig.6).
3. Adjust the feet of each Flat support to the minimum width (fig.12).
4. Position Flat over the bathtub to rest on the side edges (fig.7).
5. Adjust the feet of the supports so that the non-slip rubber pads rest against the inside
wall of the bathtub and the suction cups rest on the top of the bathtub edges (fig.8).
6. WARNING! To guarantee the stability of the product make sure to have max 55 mm from
the adjusters to the end of the legs (see fig.13).
7. To close Flat supports, press the sides of each red hook (fig.5) pushing the changing
table's supports inward and hook them in place on the side lock underneath the changing
area (fig.1).
USING FLAT ON THE TOP-RAILS OF A COT
(maximum external width of the cot 63 to 73.5 cm).
1. Fold away Flat supports making sure that they are blocked by the lock on the side
underneath the changing area (fig.1).
2. Place Flat on the cot (fig.9), taking care to ensure that the notch is positioned over the
top-rail of the cot (fig.14).
3. Flat must be fixed to the top-rails of the cot by the three Velcro straps supplied, one at
the back and two at the front of the changing table.
4. Flat should be fixed starting from one edge of the bed. If you want to place it in the
middle of the bed it must have at least 25 cm of space from both sides.
5. Thread the strap through the slot on the bottom edge of the changing table (fig.10).
Pass it under the top-rail of the cot and secure with velcro (fig.11). Repeat for the other
two anchor points.
6