To enter into the programming mode
Press key
for at least 3 sec.
The name of the parameter is displayed in the first
line. The third line indicates the value of the cur-
rent parameter.
To leave programming mode:
Automatically, if no key has been pressed during
approx. 30 s, or press key
parameter list is reached.
To scroll parameter information:
Use key
To change parameters:
Use keys
and
To store the modified parameters:
press key
9. Parameter Description
At the end of this user information brochure you
will find a detailed parameter list showing all
programmable parameters and offering space for
customer-specific programming values.
Display
Designation/ Description
"Display"
-APU- (X)
Resolution
Resolution in increments per
revolution
Value range: 0 ... 59999
-STr- (X)
Increments
Encoder increments
Value range: 0 ... 59999
-DP- (X)
Positions after the comma
Value range: "0." ... "0.000"
-DrEh- (X) Counting direction
Counting direction related to clo-
ckwise or anti-clockwise direction.
Selectable values: "I", "E"
-Ind- (X)
Index type
Selectable values: "0", "I"
-rFS- (X)
Referencing type
Referencing via referencing switch
or conjunction only
Selectable values: "Hand", "Auto"
-rEF- (X)
Reference value
Input of display va-
lue for referencing
-rEL-F
Incremental measurement enable
Selectable values: "AUS", "Ein"
-rEF-F
Reference value input enable
Selectable values: "AUS", "Ein"
MA355-S
Datum 18.04.2006
until the end of the
Art.Nr. 82850
Display
Designation/ Description
"Display"
-SEt-F
Reset via key
Selectable values: "AUS", "Ein"
-Cntr-
Control
Not implemented at present
-CodE-
Code
Set device to specified parameters
Attention! (X) = 1, 2 or 3 (channel number). The-
se parameters can be parameterized separately for
each channel.
10. Input Mode
Attention! Before starting with the programming of
the below mentioned functions, first select correct
channel via
-key.
Incremental measurement function
•
By pressing the
key (hold down) with sub-
sequent pressing of the
measurement mode is activated. A blinking dot
in the first digit indicates that the display is
being operated in the incremental measurement
mode.
•
Switching off by repeated pressing of the
(hold down) with subsequent pressing of the
key. The absolute measuring value is displayed
again.
Precondition: Menu point 'Incremental measure-
ment enable' (-rEL-F) in programming mode must
be programmed to "Ein", but unit must not be left
in programming mode.
Direct alteration or reference value
•
By pressing the
key (hold down) with subse-
quent pressing of the
input is activated.
•
The new reference value can be entered by using
the arrow keys.
•
By pressing the
key the entered value is taken
over and saved.
Precondition: In programming mode menu point
'reference value input enable' (-rEF-F) must be
programmed to "Ein", but unit must not be left in
programming mode.
enable
key the incremental
key
key the reference value
Änd. Stand 161/06
9