Kenmore PG-40405S0L-SE Benutzer- Und Patientensicherheit Seite 27

Searing Burner
9
 Remove the plastic packaging from the searing burner valve. Remove the searing burner grate
from the searing burner shelf.
 Attach the ignition wire to the searing burner valve. (A) Remove the 2 pre-installed screws from
the valve control stem and set them aside. (B)
 Loosen the searing burner to insert the gas valve. First, loosen and remove the screw attaching
the electrode (C) to the shelf and set it aside, then loosen and remove the 2 screws holding the
searing burner in place. (D)
 Insert the gas valve into the searing burner. (E) Insert the valve control stem through the hole in
the fascia. (F) Install the 2 previously removed valve control stem screws, but do not fully tighten
until the bezel has been attached to the fascia.
 Reattach the searing burner to the shelf with the 2 previously removed screws. (G) Reattach the
electrode to the shelf with the previously removed screw from the searing burner. (H)
 Insert the bezel openings over the valve control stem and the 2 screws. Slide the bezel down onto
the screws. Make sure that the black mark on bezel is vertical. Tighten the 2 screws to secure the
bezel to the fascia. (I)
 Push the control knob onto searing burner valve stem. (J)
 Place back the searing burner grid. (K)
 Insert the electrode wire into the head of the electrode. (L)
 Slide the searing burner drip box into the drip box bracket. (M)
 Unscrew the igniter cap from the right side panel. Insert (1) AA battery (provided in the blister
pack) into the battery slot with the positive end (+) facing outward. Screw the igniter cap back
onto the panel. (N)
A
C
E
B
D
F
27