4 Connecting A Tuner; 5 Connecting Loudspeakers - X4-TECH A-1000 Bedienungsanleitung

Phono connections
P H O N O C D AV 1 A V 2 T U N E R P L A
L
R
AU D I O
Connecting a tuner
Tuner
TA P E
P H O N O C D AV 1 A V 2 T U N E R P L A Y
L
R
AU D I O
› Connect your tuner's outputs to the TUNER jacks.
44 Chapter 4 Connections
TA P E E Q
Y R E C P L A Y R E C
L
R
E Q
R E C P L A Y R E C OU T PU T
L
R
Connecting loudspeakers
A two-core wire connection is required to connect the speakers. Isolate all wiring
points. Ensure that there are no sharp edges that could damage cables. Only use spea-
kers with a sufficient power rating (refer „Technical data" for more information on).
Always switch your system off before connecting or disconnecting speakers.
Connect the loudspeakers directly to the amplifier. Never use an earphone adapter
or distribution box. In case of doubt consult a specialist for further information.
Make sure that the loudspeakers are correctly polarized, i.e. that plus to plus termi-
nals and minus to minus terminals correspond.
This amplifier has been developed for operation with loudspeakers that have an im-
pedance rating of  to  ohms. Never use loudspeakers with a lower impedance
rating. Loudspeakers should only be connected to these respective outputs.
› Connect your loudspeakers to the wire clamp terminals marked SPEAKERS.
› Connect the positive (+) terminal of the left loudspeaker with the red loudspeaker terminal
marked „ LEFT+".
› Connect the negative (–) terminal of the left loudspeaker with the black loudspeaker terminal
marked „ LEFT–".
› Connect the positive (+) terminal of the right loudspeaker with the red loudspeaker terminal
marked „ RIGHT+".
Connect the negative (–) terminal of the right loudspeaker with the black loudspeaker terminal
marked „ RIGHT–".
45
Chapter 4 Connections