Joerns Healthcare Hoyer Benutzerhandbuch Seite 8

Hoyer
®
Calibre
DISASSEMBLY
Disassembly must be carried out by a competent engineer from an authorised Hoyer Service
Agent/Dealer.
The lift should not be disassembled unless for service, repair or transport if necessary. Therefore
follow the assembly instructions in reverse sequence.
ALWAYS CHECK THE FOLLOWING BEFORE OPERATION
• The mast is fully locked into position by checking the grub screws at the front and rear of the
base are tight.
• The red emergency stop button, located on the rear of the control box, is in the OFF (out) position.
8
294000.10394 Rev. B
WARNING
Front grub screw
Rear grub screw
E ng lish