Herunterladen Diese Seite drucken
TC Electronic DITTO+ LOOPER Schnellstartanleitung
Vorschau ausblenden Andere Handbücher für DITTO+ LOOPER:

Werbung

Quick Start Guide
DITTO+ LOOPER
(1)
(2)
(3)
(4)
V 3.0
(5)
(6)
(7)
(8)

Werbung

loading

Inhaltszusammenfassung für TC Electronic DITTO+ LOOPER

  • Seite 1 Quick Start Guide DITTO+ LOOPER V 3.0...
  • Seite 2 (EN) Safety Instruction No bloquee ninguna abertura de N’installez pas près de sources de chaleur Installieren Sie nicht in der Nähe von ventilación. Instale de acuerdo con las telles que radiateurs, grilles de chaleur, cuisinières Wärmequellen wie Heizkörpern, Heizregistern, Please read and follow all instructions. instrucciones del fabricante.
  • Seite 3 7. Usare solo carrelli, supporti, 7. Gebruik alleen gespecificeerde Use apenas acessórios especificados Undvik installation i trånga utrymmen pelo fabricante. treppiedi, staffe o tavoli specificati. karren, standaards, statieven, som bokhyllor. Prestare attenzione per evitare il beugels of tafels. Wees voorzichtig 7.
  • Seite 4 9. 点火したキャンドルなど、 裸の炎源を置 Unikaj instalacji w ciasnych miejscach, かないでください。 takich jak regały na książki. 10. 動作温度範囲は摂氏 度から 度 Nie umieszczaj źródeł otwartego ognia, (華氏 度から 度) です。 takich jak płonące świeczki. 10. Zakres temperatury pracy od 5° do 45°C (41° do 113°F). 安全须知...
  • Seite 5 (EN) Controls USB - Conéctese a una computadora (DE) Bedienelemente USB - Conecte-se a um computador para para importar / exportar archivos de importar / exportar arquivos de áudio e audio y actualizar el firmware. atualizar o firmware. Loop level - Passt den Loop level - Adjusts the playback level Wiedergabepegel von Loops und of loops and backing tracks.
  • Seite 6 コントロール (NL) Bediening USB - Anslut till en dator för att Power 9 V / ≥100mA -连接 电源。 (JP) importera / exportera ljudfiler och – Display 显示有关循环录制/播 uppdatera firmware. – ループとバッキングト Loop level - Past het afspeelniveau van Loop level 放, 循环模式, 循环长度和位置...
  • Seite 7 注意: ループがクリアされると、 (EN) NOTE: When the loop is cleared, DITTO+ (JP) REC / PLAY / OVERDUB は になり、 真のバイパスに turns o and returns to true bypass DITTO+ 戻ります (ES) NOTA: cuando se borra el bucle, DITTO+ se PRESS ONCE PRESS ONCE PRESS ONCE apaga y vuelve a bypass verdadero , DITTO+...
  • Seite 8 This equipment complies with Part 15 of the FCC rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and DITTO+ LOOPER (2) this device must accept any interference received, including interference that may cause undesired operation.