Herunterladen Diese Seite drucken

MARIMEX 112 Montageanleitung Seite 9

Schaukel-set
Vorschau ausblenden Andere Handbücher für 112:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• The play centre must be embedded firmly into the ground, respecting
the assembly instructions.
Only use this product when the anchoring concrete is dry.
• The anchor points must be placed at the same level or below the soil surface to
reduce the risk of tripping over.
• The anchorage must be checked regularly, in addition to the hooks and fixtures.
• The product must not be modified, otherwise risk of serious injury.
• The packaging is to be disposed of correctly. Keep packing away from of children.
• Intended for outdoor use.
Ground anchoring
1. Assemble the product, and place it on the selected area.
2. Identify and mark the position of the anchoring picket.
3. Check the product dimensions indicated in the figure ,adjust them if necessary.
4. Under each anchor position, mark a 35cm×35cm square, and dig 35cm deep.
5. Fill these holes with concrete following the figure.The level of concrete must not
be above the ground level so as to prevent any tripping over.
6. Insert anchoring picket in the concrete in the marked position. Warning:
the drilled end of the anchor should be above concrete level.
7. Once concrete is dry, screw legs of the product on the anchors.
8. Wait for complete drying of concrete before using the product.
9. Cover up each anchor with earth or sawdust, to prevent any stumbling.
Regularly check all fixations.
Maintenance
• The metal parts do not need any particular care. However, in certain regions
(ie seaside areas), certain coatings could be prone to damage. In this case,
it is advised to use a rust prevention treatment.
To prevent any danger with your product it is best to regularly check:
the fixture such as the hooks on the overhead beam.If the fixtures and hooks show
wear over 10 % of their initial thickness , then they should be replaced by exactly
the same fixtures as those originally provided.
The screws and nuts of the structure and rigging: tighten if necessary.
The presence of caps on the nuts: if absent replaced by nuts and / or identical caps.
The state of plastics (seats, footrests, slides ...) Change them if they are cracked
or pierced.
• All parts that are under constant friction can be oiled regularly whith a suitable lubricant.
• The ground on which the play centre is placed should be controlled regularly.
All elements such as stones or other objects that could cause injury in the case
of a fall, should be removed.
• It is advised to remove the structure during the winter period, when not in use, to
avoid any deterioration due to bad weather conditions.
• Check swing seats, ropes and other means of attachments for evidence
EN
9

Werbung

loading