Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2
Teaching
Please read this section completely before starting
with any teaching!
Training requires that both devices to be connected
are put into teach mode and the desired channel
must be selected for training.
The flush-mount actuators have no special teach
button. Connect the mains power capable buttons
for teaching to the button inputs (see the Installation
section). Teaching a certain actuator channel
requires pressing and holding the respective channel
button (one of the two buttons ▲ or ▼ for the blind
actuators) for about 4 seconds. Teach mode is
indicated by the device LED flashing continuously.
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
44
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
