Start Up; Simple Operating Functions With Attached Buttons - HomeMatic HM-LC-Sw1-FM, HM-LC-Sw2-FM Installations- Und Bedienungsanleitung

Permitted wire cross-section for connecting to the UP
actuators:
HM-LC-Sw2-FM and HM-LC-Bl1-FM:
Rigid wire
[mm ]
2
0.75 – 1.50
Rigid wire [mm
1.50
7

Start up

7.1 Simple operating functions with
attached buttons
You can operate the actuator using the button
connected directly to the device (teaching is not
required) and check for correct electrical installation.
Existing buttons can be used as usual.
Only the brief button press is used for operation. The
longer button press (holding longer than 4 seconds)
switches the actuator to teach mode.
Flexible wire
without end
sleeve [mm
0.75 - 1.50
]
2
Flexible wire
with end
] sleeve [mm
2
0.75
Flexible wire without
end sleeve [mm
1.50
]
2
]
2
43