Transport, Packaging And Storage - LR DDP-2 Bedienungsanleitung

5. Transport, packaging and storage

5.1 Transport
Check the dif eren al pressure gauge for any damage that may have been
caused by transport. Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging un l just before moun ng.
Keep the packaging as it will provide op mum protec on during transport (e.g.
change in installa on site, sending for repair).
5.3 Storage
Permissible condi ons at the place of storage
Storage temperature: -40 ... +70 °C
In order to prevent damage, the following points should be noted for the
storage of the pressure gauges:
■
Leave the pressure gauges in their original packaging
■
Following any possible removal of the measuring instruments, e.g. for tes ng,
the instrument should again be stored in its original packaging
Avoid exposure to the following factors:
■
Direct sunlight or proximity to hot objects
■
Mechanical vibra on, mechanical shock (pu ng it down hard)
■
Soot, vapour, dust, humidity and corrosive gases
■
Poten ally explosive environments, lammable atmosphere
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
Differenzdruckmessgerät DDP-2
Differen al pressure gauge DDP-2
f
WARNING!
Before storing the instrument, any residual media must be re-
moved. This is of par cular importance if the medium is hazardous
to health, e.g. caus c, toxic, carcinogenic, radioac ve, etc.
23
www. druck-temperatur.de • www.LR-Cal.net
MANUAL