AlzaPower APW-PS200 Bedienungsanleitung Seite 9

INSTRUCTIONS
2. Turn on USB power to the appliance by pressing the USB button.
3. Plug a USB cable into the USB port. Plug the other end of the USB cable into the proper port on
your device.
4. Once done, press USB again to turn USB power off. The station will switch to standby mode. Un-
plug the cable from the station's USB port.
5. Long-press the main switch to turn the station off completely.
UPS Backup Power Feature
1. Connect the station to mains power using the supplied adapter. The station will automatically
power on and begin charging.
2. Plug the appliance to be secured into the station's AC power socket.
3. Turn on AC power to the appliance by pressing the AC button. The station will serve the appliance
in UPS backup mode.
4. Now when the station is unplugged from the mains (or the mains lose power), the station will
power the connected device while its battery lasts.
LED lamp
1. Turn on the station by long-pressing the main power switch.
2. Long-press the lamp on / off button to turn the lamp on in low steady light mode.
3. Keep short-pressing the lamp on / off button to cycle through its other available modes: high-pow-
ered steady light, SOS, and strobe. The next short press after the last mode will turn off the lamp.
4. The lamp can also be turned off from any mode by long-pressing the lamp on / off button.
Caution:
• Only plug the station into properly grounded mains outlets supplying a stable voltage at the
normal value for your region.
• For proper function of the UPS backup feature, the total combined power draw of all connected
appliances must not exceed the input power. Otherwise, for safety reasons, the station will auto-
matically stop drawing pass-through and charging power from the mains, and will only supply the
connected devices from its own battery.
• If the display shows charge level at 0%, the UPS backup feature will still function, so long as con-
nected appliances' total combined power drain does not exceed mains input power. If it does,
the station will automatically shut down.
• When the station is discharged at high power, it and its battery pack may become excessively
hot, so that battery overheat protection activates. For safety reasons, the station will then cease to
accept high-power charging. This is normal behavior.
• Once the battery has cooled sufficiently, overheat protection will automatically deactivate and the
station will accept high-power charging again.
ENGLISH 9