AlzaPower APW-PS200 Bedienungsanleitung Seite 8

INSTRUCTIONS
Charging the Station
Only charge the station with the supplied power adapter. Charge the station fully before use.
These input ports are available for charging:
• AC input port for charging from the mains; super fast charging (300 W max. power)
• XT60 input port for charging from solar panels (solar panels not included); or
• DC5521 input port for DC charging e.g. from a car battery.
Note:
To extend the useful life of the built-in battery, we recommend charging at least once every 3 months
during prolonged periods of disuse.
Serial / Parallel Solar Charging
The station supports charging from solar panels, with 90 W maximum power.
Solar panels are not included and must be purchased separately. A connecting cable with the proper
connectors required for fast, high-power charging must also be purchased separately.
WARNING:
The station supports a maximum solar panel voltage of 28 V and maximum current of 5 A.
Caution:
The station can only be charged from a single solar panel with no more than 28 V voltage. Exceeding
this limit may severely damage the station.
Each input connector of the XT60 serial input cable must be connected to the corresponding solar
panel before use.
Using the Station
Before each use, check that the battery is installed and fully charged.
Using the Station – Alternating Current
The station can power AC appliances of no more than 500 W total combined draw.
1. Turn on the station by long-pressing the main power switch. The main power indicator and the
display will light up. The station will switch to standby mode.
2. Plug the appliance power cord into the station's AC power outlet.
3. Turn on AC power to the appliance by pressing the AC button.
4. Once done, press AC again to turn AC power off. The station will switch to standby mode. Unplug
the appliance from the station.
5. Long-press the main switch to turn the station off completely.
Using the Station – Direct Current
1. Turn on the station by long-pressing the main power switch. The main power indicator and the
display will light up. The station will switch to standby mode.
2. Plug the DC power cord of the device to be charged into the station's DC power socket.
3. Turn on DC power to the appliance by pressing the DC button.
4. Once done, press DC again to turn DC power off. The station will switch to standby mode. Unplug
the power cord from the DC socket.
5. Long-press the main switch to turn the station off completely.
Using the Station – USB Output
1. Turn on the station by long-pressing the main power switch. The main power indicator and the
display will light up. The station will switch to standby mode.
8 ENGLISH