Atag GVW250XL Gebrauchsanweisung Seite 148

Problem
The dishwasher does not start.
The dishes are not clean.
28
Possible causes
The door lock does not click in-
to place and lock.
has not been pressed.
The door is not properly closed.
You have opened the dishwash-
er to add more dishes while a
program is in progress.
The door lock has not clicked
into place and locked.
Check whether the Delayed
start option has been selected.
The plug is not plugged into the
wall socket.
A fuse/circuit breaker has been
tripped.
The spray arms do not rotate.
Spray arm holes or bearings
blocked.
Unsuitable dishwashing pro-
gram.
Incorrect detergent dosage.
Old detergent. Detergent is a
perishable product.
Action
Check the door lock. If it does
not click into place and lock,
open the door.
Press and hold Automatic
door opening until the display
starts counting down. Wait until
the countdown ends (60
seconds). Close the door.
Check that the door lock clicks
into place and locks.
Press . The display starts
counting down.
Check.
Close the door and wait. After
a while, the dishwasher contin-
ues the program.
Check the door lock. If it does
not click into place and lock,
open the door.
Press and hold Automatic
door opening until the display
starts counting down. Wait until
the countdown ends (60
seconds). Close the door.
Check that the door lock clicks
into place and locks.
Press and hold for three
seconds if you want to cancel
the Delayed start option.
Check.
Check.
Check that the dishes are not
blocking the spray arms.
Clean the spray arms. See the
chapter Care and cleaning.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as In-
tensive 70°.
Dose according to water hard-
ness. Far too much or far too
little detergent results in poorer
dishwashing results.
Avoid large packages.