Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Settings
Open the door and press
To open the dishwasher's settings menu, press and hold
Use
to step through the menu.
Open the dishwasher's settings menu
Select alternative
To exit the menu, step through it or press
Settings
2
Sounds
3
Rinse aid
4
Water hardness
5
TAB
20
.
.
Alternatives
2:00 - 2:03
A beep confirms that the control panel has been pressed.
A beep indicates when a dishwashing program has
ended.
Error messages are always indicated by a loud buzzer.
3:00 - 3:05
Setting for rinse aid dosage. The rinse aid dispenser can
be adjusted between 00 (Off) and 05 (High dosage).
Increase the rinse aid dosage:
If the dishes have water marks.
Decrease the rinse aid dosage:
If the dishes have a sticky white/blue film.
If the dishes are streaked.
Build-up of foam. If you have very soft water, the
rinse aid can be diluted 50:50 with water.
Pre-selected at factory: 04
4:00 - 4:09
Adjusting the water softener. Select a setting depending
on the hardness of the water supply. It is important that
this setting is correct!
See Water hardness in the chapter Before washing for
the first time.
For a water supply with a hardness below 6°dH (10°fH /
7°eH / 1.0 mmol/l), select 00. The water softener is deac-
tivated and no salt needs to be added.
Pre-selected at factory: 04
5:00 (Off)
Activate this setting when using an all-in-one detergent
5:01 (On)
that contains rinse aid.
and
until SEt is shown on the display.
Confirm / Next setting
Werbung
