Herunterladen Diese Seite drucken

k'nex Collect & Build Super Swing 4 Bedienungsanleitung Seite 2

Werbung

IMPORTANT STUFF
FOR PARENTS & KIDS
Keep these instructions in a handy
location. They contain important
safety information.
Read all warnings and instructions
before you start to build and
operate the model.
WARNING: CHOKING HAZARD -
Small parts. Not for Children under 3 years.
CAUTION: Keep hands, face, hair and
clothing away from all moving parts.
CAUTION: Be careful not to tip the model
over. Model should be placed on a flat and hard
surface.
Share the K'NEX experience with your child
and make building with K'NEX a family fun
adventure.
Take your time to enjoy the building process.
Don't rush!
While you're building make sure you face your
model in the same direction as the pictures
show in the instructions.
Be sure to install batteries into the motor before
you start building your motorized models.
Product and colors may vary.
BATTERY INFORMATION
Caution: To Avoid Battery Leakage
Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers' instructions.
Do not mix old and new batteries or alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium) batteries. Only batteries
of the same or equivalent type recommended should be used.
Always remove weak or dead batteries from the product; do not
short-circuit supply terminals.
Insert batteries with correct polarity (+/-) as shown.
Important Tips:
Alkaline batteries AA (LR6) are recommended.
Rechargeable batteries are not recommended.
Remove rechargeable batteries from toy before charging; they
must be charged only under adult supervision.
Non-rechargeable batteries must not be recharged.
Keep components free of dust; do not immerse or use in water.
Do not dispose of batteries in a fire; they could leak
or explode and cause injury.
Remove all batteries if the toy will not be used for a long period of time.
Do not put Rods smaller than 2 inches in any openings of the
motor; they will damage the motor, and cannot be removed.
How to Insert and
Remove Batteries:
Use a small Phillips head
screwdriver to loosen the
screw. Insert 2 fresh AA
batteries (LR6) into the
+
compartment with the
correct polarity (+/-) as
shown here.

Werbung

loading

Diese Anleitung auch für:

120723262