Devon TREAD 2 Kurzanleitung Seite 10

T R O U B L E S H O O T I N G
s y M p t O M s , C a u s E s a n d p O s s i B L E s O L u t i O n s
B e lt s n o t m o v i n g
• Is the watch in Time-Set mode?
If the watch is in Time-Set mode the belts
will be stationary. To exit the mode, press the
crown button in and release. The watch should
begin to keep time.
• Is the watch turned off?
If the watch is displaying 12:00 constantly,
it could be switched off or in Chronograph
mode. Push the crown lever up and release. If
the watch was in Chronograph mode, this will
exit the mode. If no change is made, press the
crown button in and release. If the watch was
off, it will begin its homing routine.
If none of these items resolve the issue, there may
be trouble with the battery or charging systems.
Consult the Battery and Charging section for more
information.
All manuals and user guides at all-guides.com
U n r e s p o n s i v e C r o w n
• Is the watch otherwise functioning?
If the watch is keeping time but the crown switch
is unresponsive, it is likely that something has
malfunctioned in the crown mechanism. The
watch will need to be returned for service and
repair.
• When was the last time the battery was
charged?
The watch continuously monitors the state of
the battery. If the power level drops too low,
the microcontroller will shut down the belts
to conserve power. This allows the watch to
continue to store the correct time until it can
be charged again. Charging the watch for 5-6
hours should return it to a fully charged state.
Consult the Battery and Charging section of
this document for more information.
B at t e r y a n d C h a r g i n g
• Battery Life
The capacity of all batteries decreases as they
are used. When new, the Tread 2 should last up
to 2 weeks. For best performance the watch
should be charged as often as possible. There
is no need to allow the battery to become fully
depleted before charging – in fact this can lead
to shorter battery life. Several factors could
contribute to reduced battery performance.
• Is the watch set properly in the cradle?
If the watch is not seated fully in the charging
cradle, the induction coils will not properly
couple and the watch will not charge. If using
a travel charger the box lid must be closed and
latched to secure the watch to the charging
cradle.
• Is the correct power adapter being used?
All the chargers require the same 12 Volt 0.65
Amp adapter.
• How long was the watch on the charger?
Normally it should take about 5-6 hours to
fully charge the Tread 2. Charging overnight
(12 hours) can help ensure the watch is fully
charged. It is most efficient to charge the
watch when it is off.
• Is the watch presently cold?
Lithium-polymer batteries are sensitive to
excessive cold. The effective capacity of the
battery decreases rapidly as temperature
drops below 0°C.
• Is the watch warm or hot when removed from
charger?
Some warming is normal as a result of the
energy dissipated when charging, however
if the watch is exceedingly warm (too hot to
touch) this may indicate a serious problem. The
charger should be immediately unplugged and
the watch and charger returned for testing and
service.