JBM 60043 Bedienungsanleitung Seite 9

REF. 60043
OPERATIONS
Spraying methods
1.By turning the nozzle adjustment nut to various
positions, the gun offers three types of spraying
methods: round, horizontal flat round, vertical flat
round. Users can adjust accordingly to achieve
the ideal spraying results.
Moreover, users can adjust the size and shape of
the spray by adjusting the airflow regulator.
NOTE: When adjusting the trigger, it must be released to avoid
danger. Never point the nozzle at people and animals.
Adjusting the Flow Rate
The spray rate can be adjusted by turning the knob behind the
trigger. The larger the discharge opening, the higher the spray
rate.
Spraying
Before the first spraying, the user should do some exercises on
the discarded wood or cardboard to practice using the cordless
paint sprayer.
Pre-treat the surface to be sprayed
• The spraying result depends on how smooth and clean the
surface is before spraying. Therefore, treat the surface
carefully and keep it free of dust.
• Cover areas that do you not wish to spray.
Correct spraying method
• The spray gun should be perpendicular to the surface
when spraying.
Users can choose a distance from the nozzle to the
•
surface of 5 to 30 cm depending on the size of the spray
pattern. In general, the greater the distance, the larger the
spray pattern.
•
Move the spray gun evenly parallel along the surface.
Uniform guidance of the spray gun results in a uniform
surface quality.
• Generally, spray twice, the first spray may be slightly finer,
and the second spray should be slightly coarser.
At the end of spraying, hold the gun close to the surface to
•
avoid overspray.
Cleaning the Spray Gun
NOTE: Do not immerse the gun in the detergent.
Knob behind
the trigger
· 9 ·
• Pull the trigger while spraying and release the trigger when
finished spraying. When spraying the next coat, align the
nozzle with the bottom edge of the previous spray and
allow the edges to overlap slightly for better spraying.
Do not move the gun unevenly.
•
1.Unlock the fan assembly and remove it from the gun assembly.
2.Align the release latch and remove the gun.
3.Squeeze the trigger so that the spray material remaining in the gun flows into
the tank.
4.Unlock and remove the tank and empty the remaining
residual spray material into the tank.
5.For cleaning, add some cleaning solution into the tank.
After washing, the residual liquid must be disposed properly
to avoid contamination of the environment.
6.Refill a new cleaning solution.
7.Screw the tank with the cleaning solution back onto the spray gun.
8.Spray the cleaning solution for 2-5 seconds in
the safety zone, spray for a few seconds again.
Then remove the tank and press the trigger.
9.Clean the outside of the tank.
10.Remove adjusting knob, nut, nozzle guard, nozzle, nozzle, etc.
11.Clean the tank, nozzle guard, nut, nozzle, air flow
regulator, gun assembly, etc. with a brush and cleaning
solution.
NOTE: Never use solvents, lubricants containing
silicone, a sharp metal needle or similar to clean the
nozzles. Do not neglect to clean the nozzle gasket.
12.Install the removed parts.
13.When the battery pack is not in use for a long period of time, it should be stored
separately.