JBM 60043 Bedienungsanleitung Seite 8

1.Adjusting knob
2.Nut
3.Nozzle guard
4.Nozzle
5.Seal ring
6.Air volume regulator
7.viscosity cup
8.Trigger
9.Flow regulator
10.Tank
11.Tank lockdown
12.Air filter
13.Fan assembly
14.Handle
15.Battery pack
TECHNICAL SPECIFICATIONS
Maximum viscosity 60 DIN/s
Rated voltage 20V DC
Rated power 280W
Tank capacity 900ml
Spraying distance 20cm
Spraying capacity 700ml/min
Nozzle diameter 2,5mm
Power source 2.0/4.0/6.0Ah Battery
2.0Ah lasts for 10min
Battery working duration 4.0Ah lasts for 20min
6.0Ah lasts for 30min
Material PA6 and PP
Dimensions 350x125x300mm
Weight 1.3kg
MONTAJE
Montaje de la pistola de pulverización
1.Inserte el montaje del ventilador en la pieza de
pulverización desde la posición de desbloqueo
hasta el final, y luego gire el montaje del ventilador
hasta la posición de bloqueo.
Lock the tank to the locked position.
Spraying Material Preparation
Before spraying, the spray material must be diluted with the
solvent specified by the material manufacturer. Do not use
spraying material that exceeds the specified maximum
viscosity.
NOTE: Do not use flammable spraying liquids.
1.Mix the spray material thoroughly before checking the
viscosity.
2.Completely immerse the viscosity cup in the spray material,
except for the hook part.
3.Lift the hook of the viscosity cup and record the time (in
seconds) until the liquid in the viscosity cup has flowed. These
drip times are recommended by the material manufacturers.
Spray materials must be filtered with a wire mesh prior to
spraying to prevent large contaminant particles from clogging
the nozzle.
FILLING THE SPRAYING MATERIAL
1.Remove the tank from the appliance.
2.Add the diluted filtered spray material into the tank.
The liquid level must not exceed the bottle neck of
the tank.
Carefully screw the fluid-filled tank back onto the
appliance and tighten it.
· 8 ·
REF. 60043