Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN-
Operating instructions
Conditions of safe and reliable use
1. the instruction manual enables correct installation and use, or ensures the durable and safe work of the
device.
2. the device may be used only if it has been professionally installed and is in perfect technical condition.
3. it is forbidden to connect the water tank to the mains, if the device is not fully filled with water.
4. before the first start-up and after each emptying of the tank, the tank must be vented (see point
Venting).
5. the device must not be opened (loss of warranty).
6.maximum operating pressure 6 bar.
7.water temperatures above 40 degrees C. can cause a feeling of burning especially for children.
Please also note that the armature (including batteries and pipes) can reach a higher temperature during
operation.
The device is not intended for use by persons (including children) with sensory impairments, limited physical, mental
or psychological disabilities, or persons lacking the requisite skills.
The device is not intended for use by persons (including children) with sensory impairments, limited physical, mental
or psychological disabilities, or persons lacking in specialized knowledge, unless they have been given supervision or
instruction concerning use of the device by a person responsible for their safety. Children should not handle the
Installation
Floor or wall mounting
1. The unit must always be mounted upright with the water connections facing upwards, use the 5 fixing
points for floor mounting.
2. For wall mounting, screw on the wall bracket, hang the unit and screw it to the upper mounting point.
upper mounting point. (Not for use in vehicles of any kind.)
Connection to the water supply
For operation with pressure pumps, foot pumps, hand pumps or small pumps,
submersible pumps up to max. 6 bar. The unit can be used with a pressure f i t ting or a
low-pressure f i t ting.
(Figure 1.)
Blue = cold water inlet side blue.
Red = hot water outlet side red.
The unit is designed for use in pressurised f i x ed systems. This
This system allows water to be drawn off at several draw-off points.
The unit can also be installed directly at the tapping point, even with a low-pressure f i t ting.
low-pressure f i t ting.
Venting: When the installation is complete, turn on the hot water tap until the water (without air)
comes out of the battery outlet pipe.
device as a toy.
6
Werbung
