Repair Service - TEFAL COMPACT POWER XXL Bedienungsanleitung

Instructions eco-design
This is a general purpose vacuum cleaner.
To achieve the eco-design performance on carpet, please use the dual position vacuum head, with the brush
retracted ( *).
To achieve the eco-design performance on hard oors with joints and grooves,
please either use:
• The nozzle for smooth oors with grooves* (a) without the removable brush.
• The dual position vaccum head*, with the brush retracted (
The methods used for performing eco-design are the ones described in 666/2013 of
8 July 2013 directive.
For delicate smooth oorings, such as parquet, laminated ooring or tiles, it is recommended to use either :
• The nozzle for smooth oors with grooves*, with the brush retracted (a+b).
• The dual position vacuum head*, with the brush extended (

REPAIR SERVICE

IMPORTANT : If you notice that your vacuum cleaner is not operating as well, before
carrying out any checks, switch it o using the ON/OFF pedal.
Repairs should only be performed by specialists using original spare parts.
If a problem persists, take your vacuum cleaner to your nearest Approved Service Centre or contact Customer Services.
If your vacuum cleaner does not function :
• Check that the appliance is plugged in correctly.
If the suction attachment is di cult to move :
• Reduce the power by opening the mechanical power control on the butt or by moving the electronic power
control switch towards the MIN position.
• Make sure that the position of the nozzle corresponds to the oor being vacuumed :
- for rugs and carpets, use the nozzle in the retracted brush position,
- for parquets and smooth oors, use the nozzle in the advanced position.
If the power cord does not wind up completely :
• The power cord is slow to wind up: pull the cord out again and press on the power cord rewind pedal.
If your vacuum cleaner stops during use :
• The safety mechanism was triggered. Check the tube and hose for blockage. Check if the bag and lters are
saturated. Leave 30 minutes to cool down before switching the vacuum cleaner on again.
Vacuum cleaners with bag
If your vacuum cleaner suction is not working properly or is making a whistling noise :
• There is a partial blockage in an accessory or in the hose: unblock the accessory or hose.
• The bag is full or saturated with ne dust: replace the bag* or empty the textile bag*.
• The lid is not properly closed: check the placement of the bag, of the dust bag holder and of the EPA lter
casket and close the lid.
• The lters are saturated: clean or change the ltration system EPA casket*, washable EPA lter casket*, micro-
lter casket*. See supplementary instruction manual).
If the change bag warning light is red :
• The bag is saturated: replace the bag or empty the textile bag*.
• If the warning light remains red after the bag has been replaced: the ltration system is saturated (see supple-
mentary instruction manual)
If the lid does not close :
• Check to see if there is a bag and a dust bag holder in place and make sure they are well positioned.
• Make sure that the EPA lter* casket or the micro lter* casket is well positioned.
* Model dependent: these parts are specific to certain models or they are accessories that can be purchased separately.
*).
*).
EN
*
a
b
6