Rechargeable Battery - Alzatools At-Cbbc40V Bedienungsanleitung

USE

RECHARGEABLE BATTERY

Warning: Only use battery packs specified by the manufacturer as suitable or recommended for
this tool model. Using a different battery pack can result in loss of warranty, damage to the product,
damage to property, or a serious risk of injury or death.
Recommended types of batteries and chargers
The battery and charger are not included. Only use these recommended types of batteries and
chargers.
Battery:
• AlzaTools 20LBP20V (model AT-20LBP20V)
• AlzaTools 40LBP20V (model AT-40LBP20V)
Charger:
• AlzaTools 35FCH20V (model AT-35FCH20V)
• AlzaTools 24FCH20V (model AT-24FCH20V)
• AlzaTools DCH20V (model AT-DCH20V)
Inserting and removing the battery
Follow the instructions, directions and warnings in the relevant operating instructions when handling
the battery.
Before inserting the battery, make sure that:
1. the device is switched off;
2. the battery is fully charged.
IMPORTANT: ALWAYS USE PAIRED BATTERIES OF THE SAME CAPACITY.
Align the grooves in the battery compartment at the back of the trimmer with the slots on the battery
and slide it into the trimmer until you hear a click (Fig. A). Repeat with the other battery.
Before turning on the tool, make sure both battery packs have been correctly inserted.
If you need to remove the battery, first make sure the tool is off, then press the release button on the
battery and pull it out. Repeat with the other battery.
When inserting and removing the battery, hold it firmly to prevent damage from improper handling
(e.g., falling).
Do not insert or remove the battery by force. If it cannot be easily removed, it is likely that it has not
been inserted correctly. Contact an authorized service centre.
Checking the charge status
The battery is equipped with a charge status indicator (3 LEDs). To check the charge status, press
the button on the side (Fig. C). If all LEDs are lit, the charge level is high. When two LEDs are lit, the
battery is partially discharged. If only one LED is lit, the battery is discharged and must be recharged.
TOOL ASSEMBLY AND DISASSEMBLY
The tool is delivered disassembled from the factory.
Warning: When assembling and disassembling the tool, always make sure it is switched off
and the battery is removed.
Handel installation
Warning: Always make sure that the handle is securely fastened before use. Otherwise, it may
fall off during use, potentially causing severe injury.
1. Turn the handle height adjustment lock counterclockwise (Fig. C1).
2. Disassemble the lock assembly into its component parts (Fig. C2: 1. Shaft; 2. Bottom clamp jaw;
ENGLISH 21