Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General Information
Safety instructions
Designed use
The AMFLO
MAG Basic is designed as a flow meter for conductive liquids. This unit is designed for acquisition, calculation and sending
®
information of volumetric flows within the mentioned specifications. Resulting from incorrect use or from use other than that designated,
can suspend the operational safety of the devices. The manufacturer accepts no liability for damages being produced from this.
Installation, commissioning and operation
Installation, connection to the electric supply, commissioning and maintenance of the device must be carried out by trained, qualified speci-
alists authorized to perform such works under consideration of regulations and current laws. The specialist must have read and understood
these Operating Instructions and must follow the instructions they contain.
Before working make sure to shut down the relevant system and disconnect the power supply. Furthermore ensure that nobody can activate
the relevant system or reconnect power supply without your permission.
Pay especially attention to the following points:
• Environment conditions and mounting position
• Compliance with operation data (voltage, temperature, etc.)
• Protections like for Overvoltage (suitable fuse, no electrical welding at connected systems, etc.)
Operational safety
The manufacturer reserves the right to modify technical data without prior notice. Your local distributor will supply you with current infor-
mation and updates to these Operating Instructions.
Return of the instruments
Always enclose a fully completed "Repair Form" with the device. Only then INTEGRA Metering can transport, verificate, check or repair a
returned device.
Notes on safety conventions and icons
The devices are designed to meet state-of-the-art safety requirements. They have been tested and left the factory in a condition in which they
are safe to operate. They can, however, be a source of danger if used incorrectly or for use other than the designated use.
Consequently, always pay particular attention to the safety instructions indicated in these Operating Instructions by the following
symbols:
Warning!
"Warning" indicates an action or procedure which, if not performed correctly, can result in injury or a safety hazard.
Comply strictly with the instructions and proceed with care.
Caution!
"Caution" indicates an action or procedure which, if not performed correctly, can result in incorrect operation or
destruction of the device. Comply strictly with the instructions.
Note!
"Note" indicates an action or procedure which, if not performed correctly, can have an indirect effect on operation
or trigger an unexpected response on the part of the device.
Approval, declaration of conformity and verification
This device is approved according to the MID directive 2004/22/CE and the special cooling approval according to the PTB TR K7.2. Inst-
ruments for commercial heating and cooling measurements are subject to commercial verification in most countries. Equipment subject
to this obligation must be recalibrated resp. reverificated after expiry of the calibration period. The operator is responsible for compliance
with the regulations.
AMFLO
MAG Basic
®
9
Werbung
