Adjustment - Sharp Rp-103H Serviceanleitung

RP-103H
WITH POWER ON
@® With the turntable chassis closed:
(1)
The tonearm returns to its rest position, 1 second after
the power switch has been turned on.
The side A of a record is ready to be played with the
side A play indicator lighting up and the speed is set
at 33 r.p.m. :
(2)
When the tonearm is at its rest position:
@ With the turntable chassis opened halfway:
@ With the turntable chassis opened completely:
——/-
TURNTABLE CHASSIS OPEN OPERATION |
When the turntable chassis has been closed, it opens when the
loading key is pushed.
The loading key has a priority to all
other keys.
®@ With the turntable chassis closed:
(1) aes oe h e
When the tonearm is at other than its rest position:
The open/close motor continues to rotate until the
close switch turns on.
Presettings of both sides play, repeat play operation are
cancelled. :
(2)
When the tonearm is at its rest position:
@ With the turntable chassis opened:
To open the turntable chassis, the loading key may be
pushed either when the turntable chassis has been closed
with the power
switch. turned on or when the turntable
chassis is on the way of its closing.
@ With the loading key pushed, the turntable operation gets
In stop.
position if it has been at the other position.
Note: .
The open/close motor continues to rotate until the open
switch turns on.
However, if the open/close motor rotates
for more than 2.1 seconds, it will be stopped even if the
close switch turns off. —
TURNTABLE CHASSIS CLOSE OPERATION
When the turntable chassis has been opened, it is closed when
the loading key or play/cut key is pushed.
_-» When the turntable chassis has been opened:
The open/close motor continues to rotate until the close
switch turns-on..
|When the play/cut key is pushed, the unit goes into
automatic play mode.
When the loading key or play/cut key is pushed when
the turntable chassis is on the way of its opening, the
Jopen/close motor is once stopped for 200 msec, and
then it restarts rotating in the reverse direction to close
the turntable chassis.
(2) |
When the turntable chassis is on the way of its opening:
_ AUTOMATIC PLAY START OPERATION
With the turntable chassis opened, pushing the play/cut key
causes the turntable chassis to be closed, then the unit enters
automatic play mode. |
@ Upon closing of the turntable chassis, the record size is
CIRCUIT ADJUSTMENT
that of the Service Manual for the RP-107H/117H.
~18—