Werbung
Code Change Instructions
1. If already installed, remove the lock off the door by
unscrewing the fixing bolts in the back plate.
2. Press the 'C' button to reset the chamber and place the
lock case on a flat surface with the buttons down.
3. Remove the coloured screws and carefully lift off the
code change plate. Check that all springs are held in
place on the plate.
4. Hold the lock in your hand, press and hold the 'C' button.
Keeping the 'C' button depressed use tweezers or a
pair of long nosed pliers to reposition the tumblers to
correspond with your new code. The square notches of
all tumblers must face outwards, with the square tips at
the top: See Fig.1, page 3. Do not force the tumblers in.
Note: Holding the 'C' button depressed whilst removing or
replacing the tumblers is ESSENTIAL to avoid damaging
the internal mechanism. DO NOT attempt to reposition the
'C' tumbler.
5. Replace the code change plate carefully with the
coloured screws.
6. Check the operation of the new code and make a written
note of it before reinstalling the lock.
7. Reinstall the lock according to its specific Installation
Instructions. All instructions are available online at
codelockssupport.com
2
Werbung
