Panasonic CR-593-B Bedienungshandbuch Seite 16

APPENDIX
Easy Installation of the Software for DOS / Windows 3.1
The CR-593-B/C CD-ROM drive must be installed into your host computer,
before installing this software.
1. Turn the power of your personal computer on. If your system automatically loads Windows,
you must exit Windows and reach the DOS prompt C:\.
This explanation assumes that your floppy drive is designed "A" and your hard disk
drive "C". If, however, you have used other letters to designate your drives, please substitute
the appropriate letters.
2. Insert the floppy disk "M.K.E ATAPI Device Driver" into your floppy disk drive.
3. Type A: and press <Enter>.
The current drive changes to "A".
4. Type INSTALL and press <Enter>.
The software will then ask the destination drive as well as other parameters. The software
will then be transferred, and the CONFIG.SYS, and AUTOEXEC.BAT, etc. will be changed.
5. Follow the procedures displayed on your screen until the completion message appears.
6. Eject the floppy disk from the floppy disk drive.
After the installation, keep this floppy disk for future use.
7. To restart the system, press the reset button on your personal computer, or the following
keys:
Ctrl
Check that the device driver of this equipment has been installed during the start-up
procedure.
Every time DOS is started, the device driver of this equipment will be automatically installed.
If you have installed only the device driver for Windows, you do not need to restart the
system.
All manuals and user guides at all-guides.com
+ Alt + Delete
A-13