Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHAPTER 4 GUIDE TO OPERATION
4.1 INSTALLATIONS
• Starting the drive.
Turn on the power supply.
Press the eject button. The tray is ejected from the drive.
Place the disc in the tray with the disc's label facing up.
Press the eject button or press the tray lightly as in the following figure.
The tray is retracted automatically.
Loading start.
CAUTION:
• Do not insert any foreign objects into the disc tray. This could result in a
malfunction.
• Do not manually force the tray to open.
• When the drive is not in use, keep the tray closed to protect against dust and dirt.
• Do not press down hard on the tray when loading a disc, since this may result
in damage to or malfunction of the tray.
• In case of emergency, eject the tray manually
If for some reason the tray will not eject automatically, press
the eject-bar (for example, insert a straightened paper clip
minimum straight length = 45mm, Diameter = 1~ 1.5mm)
into the emergency eject hole to manually eject the tray. (Be-
fore proceeding with this emergency step, make sure that
the power is switched OFF.)
A-8
All manuals and user guides at all-guides.com
* This figure shows in case of
Horizontal Installation.
Min. 45 mm
Paper clip
Werbung
