Werbung
Verfügbare Sprachen
Verfügbare Sprachen
►1.22. Conditions of use:
A) Air temperature: 18°C to 45°C;
Water temperature: <45°C.
B) The air supply must be free
of dust, pollutants, or additional
cleaning should be used.
►►2. UNPACKING
►2.1. Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance
with the Standards in force.
►2.2. Extract all items from the
packaging.
►2.3. Verify if damage undergone during
transport. If the appliance appears
damaged, inform the dealer, where the
purchase was made, immediately.
►►3. ASSEMBLY
The device is equipped with wheels to
facilitate handling. Depending on the
model, wheels can be found already
installed or not. Components equipped
with relative nuts and bolts are found
inside the packaging (Fig. 1).
►►4. OPERATION
WARNING: Thoroughly read the
"INFORMATION
SAFETY", before switching the
appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
WARNING: Verify if your electronic
system
is
earthed
Connection to the mains must
be made in compliance with the
National Standards in force. Power
the appliance only with voltage and
frequency as specified on the data
plate.
NOTE:
These
connected to the water mains, by
connecting the pipe to the fitting
(Fig. 10).
Figures and texts of this book are protected by COPYRIGHT.
REGARDING
correctly.
models
can
be
►►4.1. SWITCHING ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3);
water level must be within MIN and
MAX level of the graduated scale,
placed at the side of the appliance
(Fig. 4), in order to prevent risks.
►4.1.3. Close the tank door (Fig. 5).
►4.1.4. Connect the power plug to the
mains (Fig. 6).
CAUTION: When the supply plug is
connected to the power mains, the
display shows the approximate room
temperature.
►4.1.5. Press the ON/OFF button to
switch on the appliance (Fig. 9).
►►4.2. CONTROL PANEL, USE
AND FUNCTIONS (Fig. 7-8):
►ON/OFF: It allows switching ON or
OFF the appliance.
►SPEED:
Allows
decreasing the appliance ventilation
speed. Three speeds can be selected
- LOW, MID and HIGH.
►COOL: It enables or disables the
cooling mode.
►SWING: It enables or disables the
automatic vertical oscillation of the
flaps to direct the air flow.
►ANION: It enables or disables the
ionisation
mode,
negative ions into the environment, in
order to make air healthier.
►TIMER: If the device is off, it allows
programming
the
You can choose between one-hour
intervals.
►TIMER: If the device is on, it allows
programming the automatic switch-
off. You can choose between one-hour
intervals.
en
increasing
or
i.e.
release
of
delayed
start.
Werbung
