Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BBC 34-DSI
Never start the machine while changing the
►
insertion tool.
►
Before changing the insertion tool or accessories,
stop the machine, switch off the power supply and
bleed the machine by activating the start and stop
device.
►
Never point the inserted tool at yourself or anyone
else.
Make sure that the insertion tool is fully inserted
►
and the tool retainer is in a locked position before
the machine is started.
Check the locking function by pulling the inserted
►
tool outwards forcefully.
WARNING Moving or slipping insertion tool
An incorrect dimension of the inserted tool's shank
can result in that the inserted tool is lost or is slipping
out during operation. Risk of severe injury or crushed
hands and fingers.
Check that the insertion tool has the shank length
►
and dimensions that the machine is intended for.
Never use an insertion tool without a collar.
►
Operation, precautions
DANGER Explosion hazard
If a warm insertion tool comes into contact with
explosives, an explosion could occur. During
operation with certain materials as well as use of
certain materials in machine parts, sparks and
ignition can occur. Explosions will lead to severe
injuries or death.
Never operate the machine in any explosive
►
environment.
►
Never use the machine near flammable materials,
fumes or dust.
►
Make sure that there are no undetected sources
of gas or explosives.
Never drill in an old hole.
►
WARNING Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or slipping
may cause injury.
© 2010 Atlas Copco Construction Tools AB | No. 9800 0678 71 | 2010-03-22
Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Always inspect the equipment prior to use. Never
►
use the equipment if you suspect that it is
damaged.
►
Keep your feet away from the inserted tool.
Never drill in an old hole.
►
Never start the machine when it is lying on the
►
ground.
►
Never 'ride' on the machine with one leg over the
handle.
Never strike or abuse the equipment.
►
Check regularly for wear on the insertion tool, and
►
check whether there are any signs of damage or
visible cracks.
►
Pay attention an look at what you are doing.
WARNING Trapping hazard
There is risk of neck ware, hair, gloves and clothes
getting dragged into or caught by a rotating insertion
tool or accessories. This may cause choking,
scalping, lacerations or death. To reduce the risk:
Never grab or touch a rotating drill steel.
►
►
Avoid wearing clothing, neck ware or gloves that
may get caught.
►
Cover long hair with a hair net.
WARNING Dust and fume hazard
Dusts and/or fumes generated or dispersed when
using the machine may cause serious and permanent
respiratory disease, illness, or other bodily injury (for
example, silicosis or other irreversible lung disease
that can be fatal, cancer, birth defects, and/or skin
inflammation).
Some dusts and fumes created by drilling, breaking,
hammering, sawing, grinding and other construction
activities contain substances known to the State of
California and other authorities to cause respiratory
disease, cancer, birth defects, or other reproductive
harm. Some examples of such substances are:
●
Crystalline silica, cement, and other masonry
products.
Arsenic and chromium from chemically-treated
●
rubber.
Lead from lead-based paints.
●
Dust and fumes in the air can be invisible to the
naked eye, so do not rely on eye sight to determine
if there is dust or fumes in the air.
To reduce the risk of exposure to dust and fumes,
do all of the following:
9
Werbung
