Herunterladen Diese Seite drucken

Tamiya TT-01 E CHASSIS SHAFT DRIVEN 4WD Bedienungsanleitung Seite 21

Werbung

RIC BODY
PARTS
SET
FAIRLADYZ
Version
NISMO
(6A-6.5m)
*Make
position
No.1322
717L..'i*d
Z
Version
NISMO
pc-5,
PS-5
-13 •y 5
Black
*Make
rear body mount.
*Make
CAUTION
'Read
carefully and fully understand
the
instructions
before commencing
assembly.
'When
assembling this kit, tools including
knives
are used.
Extra
care
should
be taken
to
avoid personal
injury.
How to paint
'Read
and follow the instructions supplied
with
paints and/or
cement,
if used (not
included
in kit).
'Keep
out
of reach
of srnatl children.
Children must not be allowed
to put any parts
in their mouths, or pull vinyl bag over their
(3)
*Apply
*Cut off using scissors or a modeling knife.
Preparing
body for painting
*Wash
the
body
thoroughly
with
detergent in order to remove any oil,
then rinse well and allow to air dry.
This
mark
denotes
numbers
for
Tamiya
Paint
colors.
Paint
body
from
inside using polycarbonate
paints.
PC-5 PS-5'7-3,y5
/ Black
Stickers
@Ail stickers have been pre-cut. Cut out
each sticker
in nurnbered
order allowing
a slight border. Peel off surrounding
border.
@PeeI away the lining slightly and place
the sticker
in position
on the body.
@Remove the lining slowly. Be careful
not to move the sticker
out of position
and
not
to
leave
air
bubbles
under
the
sticker.
TAMSÄCOLOÄ
0208 02008
TAMIYA
can be
type
*Make 6mrn hole, matching
Trimming and painting body
two 6-6.5mm
holes, matching
the
Of front body mount.
two 6—6.5mm holes for
4.5mm
holes.
pc-5,
PS-5
Black
Cut away.
*Wash the body thoroughly with detergent then allow to air
dry. Cut out masking stickers and mask off windows from
inside.
-5-30755
*Paint
black areas from inside. When painting with spray,
fully mask Off areas not to be painted. After paint has cured,
paint silver areas. Apply thin layer of paint 2-3 times keeping
30cm distance
from body.
*After
paint
has dried,
remove
masking
stickers.
completion
of painting,
remove protective
film.
Markings
stickers in numbered order.
position of antennae
PS-12
pc-5,
PS-5
-5-3•y5
Black
*Make
4mm
holes.
PS-12
C
*Make
4mm
holes.
pc-5,
PS-5
Black
After
*Use
stickers in parenthesis ( ) when using
LED lights.
51322 Nissan Fairlady Z Version Nismo Body (11050689)
ITEM
51322

Werbung

loading