Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sawing with the mitre fence
1. Adjust the fence extrusion to the workpiece
height.
2. Hook fence assembly to the left guide bar –
tighten the knurled nut (arrow) only so much that
the fence assembly slides smoothly on the
guide bar.
3. Set and lock the required mitre angle.
A
Caution!
The fence extrusion must be at a distance of
at least 10 mm from the line of cut.
4. Set the depth of cut of the saw blade.
5. Set and lock the blade's bevel tilt.
6. Start the motor.
7. Cut workpiece in a single pass.
8. Switch machine off if no further cutting is to be
done immediately afterwards.
Care and maintenance
A
Danger!
Prior to all servicing:
- Switch machine OFF.
- Unplug power cable.
- Wait until the saw has come to a complete
stop.
· Check that all safety devices are operational
again after each service.
· Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equipment
maker can cause unforeseen damage.
· Repair and maintenance work other than
described in this section should only be carried
out by qualified specialists.
2.17
Saw blade change
A
Danger!
Directly after cutting the saw blade my be
very hot – risk of burns. Let the blade cool
down. Do not clean the saw blade with com-
bustible liquids.
Risk of cuts from the saw blade: Wear gloves
when changing blades.
On re-assembly observe direction of rotation
of saw blade and blade collar!
1. Turn the flat head screw of the table insert extru-
sion clockwise by 1/4 turn and remove the table
insert.
2. Raise saw blade fully.
3. Remove blade guard.
4. Hold up the saw blade:
- with the motor 1.7 WNB arrest the saw blade
with a wooden block
- with the 2.2 WNB and 2.8 DNB motors
remove the plastic cap and put the lock bar
through the motor shaft.
5. 5. Unscrew the arbour bolt from the motor shaft
(left-hand thread!).
TKHS 315 E
Werbung
