Werbung
Verfügbare Sprachen
Verfügbare Sprachen
@
User's Manual
SAT Multi switch
Installation
instructions:
Make sure that the system is disconnected from power during installation
Install
on a non-flammable
During installation, make sure to prevent short circuits. Make sure that you comply with
2.
the relevant European standards and VDE regulations to guarantee electrical safety
Do not reverse the main lines: (vert/horiz...)
3.
The subscribers/receivers
4.
If you encounter problems with crosstalk, apply a 75 ohm terminating resistor to
5
unused inputs/outputs.
With a universal LNB, the 22 kHz signal can also be transmitted, for example, for use on only
6
a single level (high band or low band)for horizontal and vertical To avoid jumping to the high
band, make sure to note the programming of all of the SAT receivers. If required, the high
band can be blocked using a 22 kHz blocker.
Please note that the SAT receiver must at least be compatible with the
7.
DiSEqC 1.2 switch protocol
Safety instructions:
Never use or open a defective device.
Repair work may only be conducted by an authorised specialist. As with all electronic devices,
keep the device out of the reach of children.
surface
must be connected using an antenna socket.
05.04.12
08:00
Werbung
