Security Statement
For the purpose of engraving or cutting with a laser engraving machine, allow the
workpiece to be exposed to the high-density laser beam emitted by the laser engraving
machine. The workpiece may be subject to gasification without combustion as it is pretty
hot on the surface. On the other hand, most workpieces are essentially combustible,
which may be ignited, leading to an open flame and consequently to the machine
breakdown and environmental contamination.
1. It is prohibited to store the machine in areas close to combustible and explosive
substances, volatile solvents or source or heat. Instead, store it in a well-
ventilated, cool and dust-free place.
2. Make sure that only the specific attached power cord rather than other similar
power cords are used during installation.
3. Clean the tripod and laser module with a dry cloth regularly when the power is
off.
4. Ensure to run the laser at 0°C-35°C. It is prohibited to run the machine under wet
environment or in thunderstorm weather.
5. Switch off the machine if it is offline for an extended period of time, and unplug
the power cord.
6. It is prohibited to come in contact with electronic areas with hands or other tools
when the machine is connected to power supply.
7. Touching any moving parts and laser module while the machine is running is
prohibited.
8. Before engraving, place a flat object that cannot be penetrated by the laser, such
as an aluminium alloy or stainless-steel plate on the workbench, and then place
processing material.
9. Wear goggles to prevent vision damage arising from exposure to the laser spot
during laser engraving operation.
10. It is advisable to run the machine under well ventilated condition as laser
engraving may generate small amount of fume or gas.
11. Children under 10 years old are not allowed to run the machine without adult
presence, which otherwise may lead to personal injury.
12. Put in place fire extinguishers in case of use, which shall be regularly checked. It
is prohibited to keep the machine unattended while it is running.
13. Users should comply with the laws and regulations of the corresponding
countries and regions where the equipment is located (used), abide by
professional ethics, play attention to safety obligations, and strictly prohibit the
use of our products or equipment for any illegal purpose. Creality will not be
responsible for any violators' legal liability under any circumstance.
5