JSP cobra Bedienungsanleitung Seite 4

ADJUSTMENTS:
ADJUSTMENT OF THE COBRA™ WELDING VISOR FOR COMFORT
• Before using, properly adjust your visor for maximum comfort and protection. The tension of the knobs on either side can be adjusted to set and maintain
the correct force to hold the Cobra™ Welding Visor out of your line of sight, when in the raised position. To properly adjust this mechanism for your
personal preference:
• Place the Visor on your head with the headband properly set for depth above the head and wheel ratchet tension behind it.
• The knobs on either side should be loosened until the Visor lifts freely. Lift the Visor into the raised position and then tighten both the knobs until you feel
resistance. You should now be able to raise and lower the Visor, feeling it lock positively in both positions. If you feel the Visor is still too loose, repeat
until the correct setting is achieved.
• The Visor can be adjusted to stop the lens in five different positions, check the tab arrangement on the inside of the Visor, above the knob that holds the
headband to the visor.
• This will control the position of the lens in relation to your line-of-sight when the Visor is in the lowered position.
• The correct setting will depend on the Welding Task being undertaken. See illustration below:
Note: both sides need to be adjusted equally for proper field of vision. Only proper adjustment will provide full protection against UV and IR rays at all times.
HEADGEAR ASSEMBLY DIAGRAM:
THE USER SHOULD NOT DISMANTLE THE HARNESS
Headband
Stop-
Washer
Bolt
Rake - Inner
Rake - Outer
Welding Visor
Washer
Spacer
for use between welding
& grinding shields
3
Knob