System Information; Audio/ Video Settings - Rt VOLKSBOX IDL 6650n: VOLKSBOX IDL 6651n Web-Edition Bedienungsanleitung

the user will be informed and asked to confirm the download. The user will be asked to confirm the download two
times, to help prevent accidental changes. During the download, the "OTA" message will be displayed on the TV
screen, showing the progress bar. After all data has been received, the receiver will update the current software
and automatically restart. All user preferences and channel lists will remain unchanged.
Note: OTA Updates are broadcasted over ASTRA 19.2E satellite and therefore are not available in all the
countries.
Software update via USB
The software can be updated using a USB mass storage device.
To update the software using a USB mass storage device, you will require the new software file from our website
and a USB device, such as a USB hard disk or memory stick.
a) Copy the software bin file to the root folder of the USB mass storage device.
b) Make sure the receiver is switched off.
c) Turn the receiver On while the "+" button is pressed until "On The USB" messaged is displayed on
the front panel display
d) Insert the USB mass storage device into the USB slot of the receiver.
e) The receiver will automatically copy the new software from the USB device into the receiver.
After the file has been installed and unpacked, the receiver will update the current software and automatically
restart. All user preferences and channel lists will remain unchanged.
Caution: Be careful not to interrupt the software installation by removing the USB stick, turning off the receiver,
or otherwise interrupting the installation process. If the installation is interrupted by accident, such as by a power
failure, the receiver may not boot up afterwards.
Important: Installation of a complete software bundle, including boot loader, will reset all user settings
and erase the channel list. The library will remain unchanged.

SySTem InfoRmaTIon

This menu displays information related to the software and hardware version of the receiver. This information may
be required if you request service or repair.

auDIo/ VIDeo SeTTIngS

This is where you can set the basic audio and video parameters of your digital receiver related to connections on
rear panel.
Digital Audio Out
Use this option to specify desired audio format on
the digital audio outputs (SPDIF). This option is valid
for the optical and coax outputs.
HDMI Video output
Use this option to specify the video output format on
the HDMI connector.
TV SCART
Use this option to specify the video output format on
the TV SCART connector.
HDCP
Use this option to set HDCP protocol over the HDMI
connection 'On' or 'Off'.
18