Rt VOLKSBOX IDL 6650n: VOLKSBOX IDL 6651n Web-Edition Bedienungsanleitung Seite 15

Press the ''Audio/Subtitles" key on your remote control or scroll left with the Left arrow key when the Info-banner
is displayed until the Subtitle or Soundtracks titles are displayed with the available subtitling or audio languages.
Use the directional keys on the remote control to make a selection.\
aSpeCT RaTIo
When the info-banner is displayed, scroll left with the Left arrow key until the Aspect ratio title is displayed. Press
the Down arrow key and use the arrow keys to set the picture aspect ratio.
ReSoLuTIon
Resolution allows you to set the video resolution of the picture.
1. Press the V-Format key.
2. The current resolution will be displayed.
3. Each time you press the V-Format key, the resolution changes in the following sequence: 576i/p -> 720p ->
1080->1080p -> original. Alternatively, scroll left with the Left arrow key till TV Resolution title is displayed.
Press the Down key to set the resolution.
auDIo foRmaT
When the program info-banner is displayed, scroll left with the Left arrow key until the Audio format banner is
displayed. Press the Down arrow key and use the arrow keys to select the audio format over the digital audio
outputs of the receiver.
TM TM
Notes: Dolby Digital and Dolby Digital Plus transmissions are down mixed to analogue stereo signals or looped
through "as is" over the digital audio outputs.
Some Dolby (TM) broadcasts contain stereo or stereo+center audio data and not complete 5.1 audio channels.
SLeep TImeR
You can use the Sleep timer to specify a time (e.g.
at night) at which the receiver is to switch to standby
mode. This is particularly useful if there is no person
available at this time to manually switch the receiver
to the standby mode. Scroll left with the Left arrow
key until the Sleep Timer title s displayed and set the
time for automatic switch into standby mode.
Note: When switching to standby mode, the receiver
is also able to switch off some TV sets with "Slow
Blanking" on the SCART connector.
TeLeTexT
If teletext information is available on the current
channel, the symbol will be shown in the
channel information banner. You can press
on the remote control to display this
the
information. You can use the numeric keys 0-9,
on the remote control, to enter a three-digit page
number.
STanDBy moDe
You can put the receiver in standby mode to reduce the power consumption while the unit is not in use. The
standby mode turns off some parts of the receiver, but does not fully turn off the receiver, allowing it to start up
again very quickly when the unit is turned on. If Economic is set (see User Preferences section), the receiver will
enter a deep sleep energy saving mode when switched to standby mode. When in standby mode, the standby LED
indication will be shown on the front panel.
12