Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E N
I M P O R TA N T S A F E T Y I N FO R M ATI O N FO R BAT T E RY
1.
Two A A A batter y are required for the remote control;
2.
Use the thumb press and push the bar figure on the back cover down
simultaneously, then take out the cover and remove the batter y or inser t
the batter y, after this place the cover back on the rear of the remote;
3.
This A A A batter y (non-recharged) is not to be recharged;
4.
Different types of batteries or new and used batteries are not to be mixed;
5.
Batter y is to be inser ted with the correct polarity;
6.
Exhausted batteries are to be removed from the appliance and safely
disposed of;
7.
If the remote control is to be stored unused for a long period,
the batter y should be removed;
8.
The supply terminals are not to be shor t- circuited.
C U S TO M I S E D S TA R T-U P C O N T RO L
Depending on the room temperature and the target temperature, the heater
switches on automatically to heat the room to the set temperature at the set
time. For example, if your timer is set to 6:00 p.m. and the temperature is set
to 23 °C, the heater will switch on at 5:30 p.m. to ensure that the room is 23 °C
at 6:00 p.m.
O PE N W I N D OW D E T E C TI O N
If the sensor detects a rapid drop in room temperature, this is interpreted as
an open window. A warning symbol (OPn) is displayed and the heater is au -
tomatically switched off. Af ter the indoor temperature has risen or a manual
override of the warning has been made (by operating control panel or remote
control or heat but ton on APP), the unit returns to normal operation.
45
Werbung
