Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• USB-equipment: connect the USB-charger (included) to the 12V socket to charge your smart-
phone or tablet.
Other 12V equipment can be connected to the 12V socket (when discharge current is less than
10A) or ANEN connector (when dicharge current is more than 10A and less than 50A).
GUIDELINES FOR USE
Use with a trolling engine
The ODB can handle a continuous load of 50A. As the ODB voltage remains nearly constant du-
ring use (unlike a lead battery) you will notice that thrust also remains high and constant. This
will allow you to use your trolling engine in a lower gear which can signiicantly increase the run-
time of your e-motor. As the battery capacity indicator on your e-motor has been programmed
for lead batteries it is not reliable.
Charging
We recommend using a matching 12.6V Rebelcell charger with blue ANEN connector. If you
use a diferent charger the warranty is void if damage occurs. Using unsuitable chargers can
damage your ODB and can be dangerous! You can top-up or partly charge your ODB whenever
you so desire, there is no so-called 'memory efect'. The batteries cannot be charged at tem-
peratures of 0°C and lower. It is possible to charge the ODB with a solar panel. A suitable solar
charge controller is required, more information can be found on our website.
Rebelcell charger for ODB
Read the warnings on the charger sticker before use and follow the instructions!
Step 1 connect the battery charger to the ODB by clicking the two blue connectors together.
Step 2 connect the battery charger power cord to the AC-outlet.
Step 3 set the power switch (if applicable) to "on" and the charging process will start.
The status of the charging process is indicated through LED's on the charger. Unplug the power
cord before disconnecting the charging cables from the ODB.
State of charge indicator
Your ODB comes equipped with a digital state of charge indicator. By softly pressing the power
button the indicator is activated and battery % and voltage are shown. The indicator is switched
of if you hold the power button for a few seconds. To prevent accidental discharge please leave
it in the 'of' position when not using the ODB.
Water
The ODB is splash-waterproof according to the IP65 standard and can be used in rainy condi-
tions (see remarks at the Safety precautions and Warnings section). Please note: if you connect
equipment to the 12V socket water may penetrate the ODB during rain and this can lead to
damage. Damage caused by water ingress via an open 12V socket is excluded from warranty.
Discharging
Fully discharging your ODB is not harmful. The ODB is protected by an advanced integrated
BMS (battery management system). Charge the ODB as soon as possible after a full discharge;
due to low self-discharge (~ 2% per month) voltage may drop below critical levels and damage
the ODB irreversibly. When the ODB is not in use turn of the power switch to prevent the ODB
being discharged by the charge status indicator in standby mode, If the ODB is not used for a
longer period, we recommend charging to 50% for optimum service life.
Werbung
