HeiTel Digital Video GmbH - Quick Installation Guide CamTel SVR
Preparing the
receiver PC
Establishing the
connection to the
device
Follow-up
preparation of the
receiver PC
20
TCP/IP Crossover connection from CamControl LITE to the
device
Your HeiTel
CamTel
SVR can be accessed when in its default status or
following a device reset using the following IP address: 192.168.31.95
The precondition for communication via a TCP/IP crossover network cable
between the CamTel SVR and the receiver PC with CamControl
that the devices are located in the same IP address group (here:
192.168.31.x).
Check and if necessary change the TCP/IP
settings for the network interface (Start\System
Control\Network
Connection\Properties\Internet
(TCP/IP)), via which your device is connected via
the TCP/IP crosslink cable.
Note down the current settings for the
■
IP-address and Subnet
Change these settings:
■
IP
address (e.g.):
■
Subnet
mask:
■
Start CamControl LITE. Click on the Dial button. In the Transmitter index
dialogue window, click on the Add button and then select from the next
selection menu Add new
In the dialogue window, enter a transmitter name and the IP address for the
device. IP Address: 192.168.31.95
Confirm the dialogue window with OK.
Select the new entry using the transmitter name. Establish a connection to
the device using Dial.
Carry out the parameter settings for the device (see "Parameter settings for
the device" on page
21).
Once the parameter settings for the device have been made, if necessary
reverse the changes made on the receiver PC for
mask again.
Connections\LAN
Protocol
mask.
192.168.31.66
255.255.255.0
transmitter.
LITE is
IP
address and
Subnet
CamTel SVR