Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FUNCTION KEYS:
1. MODE:
Press to select functions.
Press and hold the MODE button for 3 seconds to reset TIME,
DISTANCE and CALORIES.
2. SET: Press to set values of TIME, DISTANCE and CALORIES
when not in scan mode.
Press the MODE button to select desired functions: TIME,
DISTANCE or CALORIES.
Use the SET button to set a value for TIME, DISTANCE or
CALORIES.
The value of a function will be set on a countdown.
Press the MODE button once more, to save the function value you've created.
3. RESET: Press to reset TIME, PULSE, DISTANCE and CALORIES to zero when not in scan
mode.
FUNCTIONS:
1. SCAN: Press MODE button until SCAN appears. The meter will rotate through all 6
functions: TIME, SPEED, DISTANCE, TOTAL DISTANCE, CALORIES and RPM. Each
display will be held for 6 seconds.
2. TIME (TMR): Counts the total time of the exercise from start to finish.
3. SPEED (SPD): Displays the current speed.
4. DISTANCE (DST): Counts the distance of an exercise from start to finish.
5. TOTAL DISTANCE (TOTAL): Counts the total distance after installing the batteries.
6. CALORIES (CAL): Counts total calories burned during exercise from start to finish.
7. RPM: Displays the current RPM.
8. PULSE: Press MODE button until PULSE appears. In order to properly measure your
heartbeat rate, you must place both your palms on the contact pads located on the
armrest. Once you have done this, the meter will show your current heartbeat rate in beats
per minute (BPM) after 3~4 seconds.
NOTE: During the process of "pulse measurement", the measurement value may be
higher than virtual heartbeat rate during the first 2~3 seconds as a result of the contact
jamming. Afterwards, it will return to normal level. To ensure testing accuracy, it is
suggested that user tests pulse during stop/pause exercise to avoid any possible
influence.
The measurement value cannot be regarded as the basis of medical treatment.
AUTO ON/OFF & AUTO START/STOP: If the wheel is in motion or any button is pressed,
the meter will become active and shall remain active. The meter will turn off automatically if
there is no motion or button pressed for 4 minutes.
ALARM: The functions of TIME, DISTANCE and CALORIES can be set to countdown, if any
of the above value goes to zero, the meter will alarm for 10 seconds.
Press MODE to select the function, then press SET to adjust the value.
NOTE: The meter containing only the "MODE" button does not have ALARM function. If you
find "M" on the left side of meter screen, it is the Imperial system. The unit will be expressed
as mile.
EXERCISE METER
20
Werbung
