Sunny Health & Fitness SF-E905 Benutzerhandbuch Seite 13

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-
907-8669).
ASSEMBLY INSTRUCTION
STEP 1:
Remove 2 Shipping Tubes (No. A) from the
Main Frame (No. 1). Then remove 4
Carriage Bolts (No. 6), 4 Arc Washers (No.
7) and 4 Domed Nuts (No. 8) from Front
Stabilizer (No. 2) and Rear Stabilizer (No. 3)
using Spanner (No. 100).
Attach the Front Stabilizer (No. 2) and Rear
Stabilizer (No. 3) onto the Main Frame (No.
1) with 4 Carriage Bolts (No. 6), 4 Arc
Washers (No. 7) and 4 Domed Nuts (No. 8)
that were just removed. Tighten and secure
with Spanner (No. 100).
NOTE: Ensure that all bolts and washers are
in place and partially threaded in before
completely tightening any of them.
STEP 2:
Connect the Lower Sensor Wire (No. 16) to
the Upper Sensor Wire (No. 15), and then
connect Tension Hook (No. 17) with
Tension Cable (No. 10b) as shown in
Diagram A.
NOTE: Make sure the Tension Controller
(No. 10a) is at the lowest level before you
connect the Tension Cable (No. 10b). This
ensures the wires are at their longest point.
We recommend the assistance of a second
person to help hold the Handlebar Post (No.
9). This will make the connection easier when
you are attaching Tension Hook (No. 17) to
Tension Cable (No. 10b).
Remove 4 Allen Bolts (No. 13) and 4 Arc
Washers (No. 14) from the Handlebar Post
(No. 9) with Allen Wrench (No. 101). Insert
the Handlebar Post (No. 9) into the post of
the Main Frame (No. 1) with 4 Allen Bolts
(No. 13) and 4 Arc Washers (No. 14) that
were just removed with Allen Wrench (No.
101).
NOTE: Ensure that all bolts and washers are
in place and partially threaded in before
completely tightening any of them.
12