Sunny Health & Fitness SF-E905 Benutzerhandbuch Seite 15

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-
907-8669).
If you experience any trouble with this step; please STOP and read our alternate assembly
directions below before continuing. Incorrect installation can result in permanent damage to your
machine. Please try below alternate assembly suggestion.
STEP A:
Disconnect the Connecting Joints (No. 19)
from the Pedal Support Tubes (No. 18L/R)
by removing 2 Hex Bolts (No. 51), 2 Flat
Washers (No. 54) and 2 Nylon Nuts (No.
56) using 2 Spanners (No. 100).
STEP B:
Attach the Left Hinge Bolt (No. 49L) through 1
Wave Washer (No. 61) and 1 Connecting
Joint (No. 19), then screw into the left side of
Crank Arm (No. 52). Turn the Left Hinge Bolt
(No. 49L) counter-clockwise as tightly as you
can with your hand. Secure by tightening 1
Spring Washer (No. 39) and 1 BLACK color
Left Nylon Nut (No. 40L) clockwise to the
thread end of Left Hinge Bolt (No. 49L). Then
use Allen Wrench (No. 102) and Spanner
(No. 100) to tighten.
Attach the Right Hinge Bolt (No. 49R) through
1 Wave Washer (No. 61) and 1 Connecting
Joint (No. 19), then screw into the right side of
Crank Arm (No. 52). Turn the Right Hinge
Bolt (No. 49R) clockwise as tightly as you can
with your hand. Secure by tightening 1 Spring
Washer (No. 39) and 1 WHITE color Right
Nylon Nut (No. 40R) counter-clockwise to the
thread end of Right Hinge Bolt (No. 49R).
Then use Allen Wrench (No. 102) and
Spanner (No. 100) to tighten.
You can now reattach the 2 Connecting
Joints (No. 19) to the Pedal Support Tubes
(No. 18L/R) with 2 Hex Bolts (No. 51), 2
Flat Washers (No. 54) and 2 Nylon Nuts
(No. 56) that were removed by using 2
Spanners (No. 100).
Attach 4 Nut Caps (No. 41) onto the 2
Connecting Joints (No. 19).
14